Salt spray corrosion test box functionality: The heated salt spray corrosion test chamber box liner sink heating, heating up fast, uniform distribution of temperature and humidity. The sample holder into the upper and lower layers are tilted at 15 degrees and 30 degrees, also can be linked to the way the national standard. Wuhan corrosive salt spray chamber hot and humid system to an independent external humidification boiler, automatic moisture control required supplement to the cabinet circular duct; drying the same for a separate heating system, exhaust system exhaust cabinets excess of wet gas; design a storage solution with the test box with the same volume of reserves cabinet and the solution conversion systems; equipment control system design on both sides of the cabinet, simple operation Wuhan corrosive salt spray chamber, the rear of the installation of the control cabinet a exhaust fan, and the heat generated in the work is distributed to the outside of the device. 1, the salt spray environment, continuous salt spray exposure is widely used to test components and coatings corrosion resistance. Applications include industrial, maintenance, construction and marine coatings; plating and paint layer; aviation and military coating, surface and components, electrical and electronic systems and components. 2, dry environment of corrosive salt spray chamber during the drying function, the fan work to make indoor air to the air heater and then entering the box dehumidification system inside the moisture to escape outside the box, thus creating the box within the low humidity conditions. Of the cabinet the temperature is controlled by the cabinet heater and the air heater. Air heater off for 5 seconds before the end of the drying procedure, so that the heater channels and components near the blower Close overheating. Wuhan corrosive salt spray chamber installation and commissioning: our service personnel of your company to the designated place of receipt within three working days after the equipment arrived to your site to complete the installation, commissioning, acceptance, operation training, you should be ready for acceptance of equipment required test conditions, such as: water, electricity, gas, test samples, and the need to meet the acceptance of our personnel. The cause can not be scheduled acceptance as a result of your reason, we can according to your requirements rescheduled, but does not affect the payment terms. As a result of our quality problems led to the acceptance of the contract by both parties convention and the convention next acceptance date. Factory outlets: Wuhan still testing experience Equipment Co., Ltd.